Aqua sense sensus water meter install#

'Can I not use a union and install them with regular couplings or maybe use a soldered female adapter?'ДЄ. We don't know why anyone would prefer it that way but, we do sell/offer them. Many are still in existence in cubic foot measurements and some water companies still use the cubic foot measurement instead of in gallons. 'Why would anyone want these meters in cubic foot increments instead of gallon measurements?'ДЄ. Compatible with Sensus, Neptune, Badger, Elster, and Hersey water meters.Not for submersible or pit installations.Multiple registers can be connected to this single SmartPoint.Allows water utilities to effectively detect leaks in a water system.Instantly transmits top of the hour readings and other diagnostic information to water utilities when used as fixed base end-point.

Can be used as a fixed base endpoint to interact with a Regional Network Interface (RNI) (requires a base station).

Collects data and waits for an activation signal from the Vehicle Gateway Base-station (drive-by) or Hand-Held Device (walk-by) to transmit readings, meter identification and any alarms.

TouchCoupler design enables connection to the water meter using existing AMR two-wire installations instead of installing a new three-wire system into a home, saving water utility installation costs.

Allows water meters to interface with the FlexNet В® communication network.

Remotely sends input information from the water meter register to a walk-by or drive-by collection device carried by water utility worker.

Radio transceiver gives water utilities access to water meter information through a radio signal.

The Sensus 510M FlexNet В® SmartPoint В® features: (two flanges needed per meter for new installations)Дў-Bolt Oval Flange - 2 FIPT - for 2' water meter в†“ Water Meter Unions and Flanges - sold individually в†“Дў-Bolt Oval Flange - 1-1/2' FIPT - for 1-1/2' water meter View Omni R2 dimensions and specifications

ADA Compliant & Independent Living AidsДЎ-1/2' Omni R2 - WITH Strainer - 13' Length.

Use the checklists in the Outdoor Visual Leak Inspection ( Section 2) and Indoor Visual Leak Inspection ( Section 3) to conduct visual leak inspections around your home. Visual Inspection MethodД¬onduct the Visual Inspection Method if you did not detect a continuous leak when you performed the Leak Detection Test ( Section 1) or if you are uncomfortable with the Isolation Method. If you are comfortable turning valves on and off, go to Isolation Method for Continuous Leaks ( Section 4). You will turn water supply valves 'off' to prevent water from flowing into water supply pipes. This is often the quickest way to locate ongoing, hard-to-find leaks. If your Leak Detection Test ( Section 1) indicated a continuous leak, consider using the Isolation Method to discover the leak location.

The purpose of the Isolation Method is to isolate different sections of the plumbing in and around your home. A brief description of both methods follows. This guide provides two methods to detect the location of leaks: the Isolation Method and the Visual Inspection Method. To determine if you have a slow leak follow Step 3 above. Some leaks are very slow and may not show as a continuous flow.If the number is greater than zero on any of the flashes, you have a continuous leak. Observe the flow rate screen for at least 10 flashes.If Gallons Used is greater than zero you have a continuous leak.Subtract the first water meter reading from the second.Wait 20 minutes then read your water meter again and record the numbers.Use the number indicated by the sweep arm as the final digit. Read your water meter and record the numbers in the boxes we've provided (' Fill in your meter readings Fill in your meter readings').Some leaks are so small that the movement is almost undetectable. If it is moving, you have a continuous leak. Step-by-Step Instructions For Analog Display Meters

Aqua sense sensus water meter